This belt kit comes with a 1.5" wide brown latigo leather strip.  The buckle end comes prepunched. 

Directions:

1. Skive the buckle area of belt down to needed thickness.

2. Edge crease the belt edges with an edge creaser (optional).

3. Bevel and sand down all four edges.

4. Burnish edges. 

5. Apply desired edge finish and flesh side finish.

6. Install the center bar buckle in the correct direction.

7. Install the Chicago screws.  Put loctite in screw hole at the very end after you're sure it's all correct.

8. Measure the distance to your required holes, and then punch the holes.

9. (Optional) For an additional level of luxuriousness, stitch the edges of the belt.

Contains: prepunched buckle end belt strip, two sets of chicago screws, and brushed nickle center bar buckle.

Build Video Courtesy of @HobbiesWithHobbs